UDIOVIZUÁLNÍ DIDAKTICKÁ POMŮCKA PRO R UČNÍ TVÁŘENÍ KOVŮ A UDIOVISUAL DIDACTIC TOOL FOR M ANUAL METAL FORMING A

The study deals with an evaluation of the machine parameter setting on the profile parameters of surface waviness on samples made of two metal materials Al 99.5 and

The formulation of a metal plasticity constitutive model with a new cyclic hardening rule is proposed to enable correct simulation of the material response under large strain

Cuts nos. 1 to 5 were formed according to the pro- posed cutting parameters. It was demonstrated that the metal was not completely cut through with the parameters set for no. for

Závislost tlaku a teploty metal-hydridového zásobníku načase při

The paper describes compartment physically adequate approach to searching of suitable cybernetic-mathematical model of behaviour of equipment of the pouring ladle with RH chamber

The central region with small defects that influence the quality of the metal samples has been successfully automatically detected.. The classification results obtained by the

However, there have been attempts to indirectly constrain the masses of Pop III stars by comparing the cumulative elemental yield of their su- pernovae to the fossil chemical

Cuts nos. 1 to 5 were formed according to the pro- posed cutting parameters. It was demonstrated that the metal was not completely cut through with the parameters set for no. for