External + Internal Finishing

CZECH TECHNICAL UNIVERSITY IN PRAGUE. HP

The last set of simulations were performed by applying the SST k-ω model with Production Limiter and Production Kato-Launder options activated for different position of the draft

b) Finding an optimal Multiphase model to compare the results with the existing geometry, various analyzes will be run on ANSYS 2020 R1 software with different time steps and

i. To improve the mesh quality, conversion of tetrahedral mesh elements to polyhedral were done in ANSYS Fluent. The power characteristics of the PBT impeller was compared

a) A literature research was done to find scientific work related to heat transfer in an agitated vessel with pitched blade turbine impeller and found out the interesting facts

In this study, total axial shortening of two buildings, separated by expansion joint, constructed at various construction speed, will be assessed to investigate the total

As their name suggests, shear thickening or dilatant fluids behave conversely to shear thinning fluids. When under shear, the apparent viscosity of dilatant fluids increases. This

In the same data set (epoch) from t>150[s] the HONU-MRAC is applied as an adaptive parameter control loop where the gain parameter p is manually updated sample-by-sample