• Nebyly nalezeny žádné výsledky

Effect of soaking temperature on the microstructure and mechanical properties of heat treated Al-Si-Nb TRIP steel

N/A
N/A
Protected

Academic year: 2022

Podíl "Effect of soaking temperature on the microstructure and mechanical properties of heat treated Al-Si-Nb TRIP steel"

Copied!
1
0
0

Načítání.... (zobrazit plný text nyní)

Fulltext

(1)

Modern trends in material engineering 10–13 September 2019, Pilsen, Czech Republic

44

Effect of soaking temperature on the microstructure and mechanical properties of heat treated Al-Si-Nb TRIP steel

Corresponding author:

Ludmila Kučerová, skal@rti.zcu.cz, University of West Bohemia, Regional Technological Institute

Co-authors:

Karolína Burdová, Adam Stehlík Abstract:

Two-step heat treatment with bainitic hold at 425 °C was applied to low alloyed high strength steel with partial substitution of silicon by aluminium. The steel was further micro-alloyed by niobium. Various soaking temperatures in the range of 750-1250 °C were used to analyse the effect of soaking hold on mechanical properties and microstructure of the steel. According to calculations in JMatPro, the temperatures below 900 °C should lie in an intercritical (tow phase) region, while the temperature of 900 °C should be the first one to ensure full austenitization of this steel. To dissolve different portion of niobium into solid solution, higher soaking temperatures were also used. Tensile strengths of 780-1069 MPa and total elongation of 22-46 %.

Key words:

Heat treatment, TRIP steel, retained austenite

Odkazy

Související dokumenty

The toughness (≈ cracking resistance and wear resistance) depends not only on mechanical properties of the film, but strongly depends on the structure,

by the President of the Republic of Azerbaijan after being evaluated by the Observation Council every year. In accordance with the investment rules, SOFAZ fully accepts

The theoretical chapter covers the fundamental basis of Natural Resource Curse along the lines of Dutch Disease and discusses possible macroeconomic drawbacks and negative

The aim of this diploma thesis "…is to test the existence of the Dutch disease in the economy of Azerbaijan and to explain the economic disease in terms of the country's

The purpose of this work was to assess the relationship between FDI and Economic Growth of Kazakhstan and the effect of FDI on Domestic Savings, as well as

Complex assessment (it is necessary to state whether the thesis complies with the Methodological guidelines of the Faculty of Economics, University of Economics, Prague as concerns

Complex assessment (it is necessary to state whether the thesis complies with the Methodological guidelines of the Faculty of Economics, University of Economics, Prague as concerns

The analysis includes experimental results from monotonic tensile tests, results from variable strain amplitude tests, results from constant strain amplitude tests, results