• Nebyly nalezeny žádné výsledky

CZECH TECHNICAL UNIVERSITY IN PRAGUE Faculty of Mechanical Engineering, Department of Process Engineering

N/A
N/A
Info
Stáhnout
Protected

Academic year: 2022

Podíl "CZECH TECHNICAL UNIVERSITY IN PRAGUE Faculty of Mechanical Engineering, Department of Process Engineering"

Copied!
1
0
0

Načítání.... (zobrazit plný text nyní)

Stáhnout nyní ( 1 Stránka )

Fulltext

(1)

CZECH TECHNICAL UNIVERSITY IN PRAGUE

Faculty of Mechanical Engineering, Department of Process Engineering

Evaluation of Diploma Thesis

Study program: Mechanical Engineering Study field: Process Engineering

Author:Hector CALVOPINA

Title:CFD simulation of heat transfer in an agitated vessel with a draft tube

The author accomplished the given tasks very well. He performed numerical simulations of fluid flow and heat transfer in an agitated vessel with a draft tube using ANSYS Fluent. The author showed good skills when postprocessing the results using MATLAB software. I would expect a little more autonomy when performing the numerical simulations and working on the thesis, but on the whole, the student showed abilities and knowledge on very good level.

Evaluation: very good (B)

19. 6. 2018

Ing. Karel PETERA, Ph.D.

Odkazy

Stáhnout nyní ( PDF - 1 Stránka - 31.27 KB )

Související dokumenty

CZECH TECHNICAL UNIVERSITY IN PRAGUE FACULTY OF MECHANICAL ENGINEERING Department of Process Engineering

Author acquired new theoretical and practical experiences and knowledge in the field of experimental methods and CFD analysis. Somireddy fulfilled all aims of

CZECH TECHNICAL UNIVERSITY IN PRAGUE Faculty of Mechanical Engineering, Department of Process Engineering

Author performed numerical simulations of fluid flow and heat transfer in an agitated vessel with a pitched six-blade turbine impeller in ANSYS Fluent.. He used “Sliding Mesh”

2. CzechParticipationinLOFT 1. Introduction:TheLOFTMission CZECHCONTRIBUTIONTOLOFT

a Astronomical Institute, Academy of Sciences of the Czech Republic, CZ-25165 Ondřejov, Czech Republic b Czech Technical University in Prague, Faculty of Electrical

CZECH TECHNICAL UNIVERSITY IN PRAGUE FACULTY OF MECHANICAL ENGINEERING DEPARTMENT OF PROCESS ENGINEERING

We previously listed different membrane separation principles in Figure 7. The main prerequisite for membrane separation is pressure difference between feed and

Ad: Eightieth Birthday of Prof. Karel Kozel

In 1964 he moved to the Department of Mathematics, Faculty of Mechanical Engineering at the Czech Technical University in Prague as an assistant professor.. Since 1988 he has been

Generalized Relay Shifting Method for System Identification M. Hofreiter

Department of Instrumentation and Control Engineering, Czech Technical University in Prague, Faculty of Mechanical Engineering, Czech Republic, (e-mail: milan.hofreiter@fs.cvut.cz )

CZECH TECHNICAL UNIVERSITY IN PRAGUE Faculty of Mechanical Engineering, Department of Process Engineering

I appreciate that there is a lot of information about settings of FLUENT solver in the thesis, but I miss there information how the residence times were evaluated – did you really

CZECH TECHNICAL UNIVERSITY IN PRAGUE FACULTY OF MECHANICAL ENGINEERING Department of Process Engineering

Author acquired new theoretical and practical experiences and knowledge in the field of modelling of particles motion by FVM method. Ronzón fulfilled all aims of